Loudwise
Free online sound test

Sound test for speakers and headphones

A quick audio test for laptop speakers, headphones, earbuds and sound systems: left and right, stereo and bass, in a few clicks. It runs in your browser, starts quiet and records nothing.

Sound plays only after you click, and the volume starts low, at 30%. Wearing headphones? Turn your device down first. Stop or the Esc key silences it at once.

30%

Left and right audio test

Press Left: the sound should come only from the left speaker or earpiece. Then press Right. Both plays from the middle, and Left ↔ right switches sides by itself.

Sound

Stereo test: in phase or out of phase

In phase, both speakers push together: the noise sounds solid and comes from the middle. Out of phase, it sounds wide and hollow, with less bass. If In phase sounds like that, one speaker’s + and − wires are swapped.

Bass test and frequency sweep

Play the bass sweep and press Stop as soon as you hear a tone: that is about the lowest note your speakers or headphones play. Listen for rattles too. The full sweep runs from 20 Hz to 20 kHz.

Nothing is playing.

Speaker test in three steps

How to test your speakers and headphones

1. Left and right

Press Left, then Right: each side should play alone, on its own side. If not, the headphones are on backwards or a cable is crossed.

2. Stereo phase

Compare In phase and Out of phase: In phase should sound fuller and centred. On a phone with one speaker, Out of phase can go almost silent, as the two sides cancel.

3. Bass and range

Play the bass sweep and stop at the first tone you hear. Laptop speakers usually fade out below 100 to 200 Hz; headphones and subwoofers go much lower.

Speakers fine, but a video still too quiet?

Loudwise is a free Chrome extension that makes any tab louder, up to 600%, with a limiter against crackle, plus Balance and Mono for a weak side. See what Loudwise does.

Coming soon to the Chrome Web Store
FAQ

Sound test questions

How do I test left and right audio?

Press Left: the chime should come only from the left speaker or earpiece. Then press Right. If the sides are swapped, the headphones are on backwards or a cable is crossed. Left ↔ right switches sides by itself, about every second.

Why is one side quieter than the other?

First check the balance setting of your computer or phone (on phones it is in the accessibility settings). Dust in an earbud or a worn speaker does it too. For sound in Chrome, Loudwise’s Balance shifts any tab’s sound towards the weak side, and Mono plays everything on both sides.

What does the stereo phase test show?

Whether both speakers push and pull together. In phase, the noise sounds solid and comes from between the speakers. Out of phase, one speaker pulls while the other pushes: the sound gets wide and hollow and loses bass. If In phase is the hollow one, the + and − wires of one speaker are swapped.

How do I test my bass or subwoofer?

Play the bass sweep (20 to 200 Hz) and press Stop when you first hear the tone: that is about the lowest note your system plays. Raise the volume slowly and listen for rattles and buzzing. To hold one low note, use the tone generator.

Why can’t I hear anything?

Check that the tab and your device are not muted and that the volume here is above zero. On an iPhone, turn off silent mode: it silences web pages too. Very low tones do not play on small speakers at all.

Is this sound test safe for my ears?

It plays only after you click, and the volume starts at 30%. Turn your device down before you put headphones on, raise the volume slowly, and press Stop or Esc to silence it at once.

Does the sound test use my microphone or record anything?

No. The test sounds are made in your browser. Nothing is recorded or uploaded, and the page never asks for the microphone.